Table of Contents
Advertisement
Back to Contents Page
Hard Drive
Dell™ Inspiron™ 1546 Service Manual
Removing the Hard Drive
Replacing the Hard Drive
WARNING:
Before working inside your computer, read the safety information that shipped with your computer. For additional safety best
practices information, see the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance.
WARNING:
If you remove the hard drive from the computer when the drive is hot, do not touch the metal housing of the hard drive.
CAUTION:
Only a certified service technician should perform repairs on your computer. Damage due to servicing that is not authorized by Dell is
not covered by your warranty.
CAUTION:
To prevent data loss, turn off your computer (see
drive while the computer is On or in Sleep state.
CAUTION:
To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal
surface (such as a connector on your computer).
CAUTION:
Hard drives are extremely fragile. Exercise care when handling the hard drive.
CAUTION:
To help prevent damage to the system board, remove the main battery (see
computer.
CAUTION:
When you disconnect a cable, pull on its connector or on its pull-tab, not on the cable itself. Some cables have connectors with locking
tabs; if you are disconnecting this type of cable, press in on the locking tabs before you disconnect the cable. As you pull connectors apart, keep
them evenly aligned to avoid bending any connector pins. Also, before you connect a cable, ensure that both connectors are correctly oriented
and aligned.
NOTE:
Dell does not guarantee compatibility or provide support for hard drives from sources other than Dell.
NOTE:
If you are installing a hard drive from a source other than Dell, you need to install an operating system, drivers, and utilities on the new hard
drive (see the Dell Technology Guide).
Removing the Hard Drive
1. Follow the procedures in
Before You
2. Remove the battery (see
Removing the
CAUTION:
When the hard drive is not in the computer, store it in protective antistatic packaging (see "Protecting Against Electrostatic Discharge"
in the safety instructions that shipped with your computer).
3. Remove the two screws that secure the hard drive assembly to the computer base.
4. Slide the hard drive assembly out of the hard drive compartment.
1
screws (2)
2
5. Remove the two screws that secure the hard drive bezel to the hard drive.
Turning Off Your
Begin.
Battery).
hard drive assembly
Computer) before removing the hard drive. Do not remove the hard
Removing the
Battery) before working inside the
Advertisement
Table of Contents
