1
display assembly
3
display cable connector
Replacing the Display Assembly
1. Follow the procedures in
Before You
2. Place the display assembly in position and replace the four screws that secure the display assembly to the computer base.
3. Route the display cable and camera cable into their routing guides and connect the cables to the respective system board connectors.
4. Route the Mini-Card antenna cables, and guide the cables to the bottom of the computer through the cable routing slot.
5. Replace the keyboard (see
6. Replace the center control cover (see
7. Replace the two screws at the bottom of the computer.
8. Route the Mini-Card antenna cables through the routing guides at the bottom of the computer, and replace the Mini-Card (see
9. Replace the hard drive (see
10. Replace the memory module(s) (see
11. Replace the module cover (see
12. Replace the battery (see
Replacing the
CAUTION:
Before turning on the computer, replace all screws and ensure that no stray screws remain inside the computer. Failure to do so may
result in damage to the computer.
Display Bezel
Removing the Display Bezel
CAUTION:
The display bezel is extremely fragile. Be careful when removing it to prevent damaging the bezel.
2
screws (4)
4
camera cable connector
Begin.
Replacing the
Keyboard).
Replacing the Center Control
Replacing the Hard
Drive).
Replacing the Memory
Module(s)).
Replacing the Module
Cover).
Battery).
Cover).
Replacing the
Mini-Card).