Table of Contents
Advertisement
NOTE:
The original thermal pad can be reused if the original processor and heat sink are reinstalled together. If either the processor or heat sink is
replaced, use the thermal pad provided in the kit to ensure that thermal conductivity is achieved.
NOTE:
This procedure assumes that you have already removed the processor heat sink and are ready to replace it.
1. Follow the procedures in
Before You
2. Align the five captive screws on the processor heat sink with the screw holes on the system board and tighten the screws in sequential order (indicated
on the processor heat sink).
3. Replace the Mini-Card (see
4. Replace the memory module(s) (see
5. Replace the module cover (see
6. Replace the battery (see
Replacing the
CAUTION:
Before turning on the computer, replace all screws and ensure that no stray screws remain inside the computer. Failure to do so may
result in damage to the computer.
Back to Contents Page
Begin.
Replacing the
Mini-Card).
Replacing the Memory
Module(s)).
Replacing the Module
Cover).
Battery).
Advertisement
Table of Contents
