Chapter 4 Installation; Notes On Drive Handling - Fujitsu MCM3064SS Product Manual

CHAPTER 4 Installation

4.1

Notes on Drive Handling

4.2 Connection Modes
4.3 Settings
4.4 Mounting
4.5 Cable Connections
4.6 Operation Confirmation and Preparation for Use after Installation
4.7 Dismounting Drive
This chapter describes notes on handling the drives, connection modes, settings,
mounting the drives, cable connections, and operation confirmation and
preparation for use after installation, and notes on demounting the drives.
4.1 Notes on Drive Handling
(1) General notes
Note the following points to maintain drive performance and reliability:
(2) Unpackaging
a) Make sure that the UP label on the package is pointing upward and start
unpacking on a level surface. Handle the drive on a soft surface such as a
rubber mat, not on a hard surface such as a desk.
C156-E228-02EN
1) Shock or vibration applied to the drive that exceeds the values
defined in the standard damage the drive. Use care when
unpacking.
2) Do not leave the drive in dirty or contaminated environments.
3) Since static discharge may destroy the CMOS devices in the
drive, pay attention to the following points after unpacking:
Use an antistatic mat and wrist strap when handling the
drive.
Hold the mounting frame when handling the drive. Do
not touch the PCA except when setting the switches.
4) When handling the drive, hold both sides of the mounting
frame. When touching other than both sides of the mounting
frame, avoid putting force.
5) Do not forcibly push up the end of the header pin of the printed
circuit board unit when handling or setting the drive.
4-1