Settings - Fujitsu MCM3064SS Product Manual

(c) Connecting more than one optical disk drive (multi-host)
Figure 4.3 SCSI bus connection modes (2 of 2)

4.3 Settings

Before installing the drive in the system, set the following setting terminal, setting
switches, and SCSI terminating resistors:
Setting terminal : CNH1
Setting switches : SW1
Figure 4.4 shows the positions of the setting terminal and switch.
C156-E228-02EN
1) The user must not change the settings of terminals not described
in this section. The terminals must remain as set when shipped.
2) Do not change terminal settings when the power is on.
3) To strap setting terminals, use the jumper shipped with the
drive.
4.3 Settings
4-5