Table of Contents
Advertisement
CHAPTER 3
This chapter describes environmental, mounting, power supply, and connection requirements.
3.1
Environmental Requirements
The environment in which these drives are installed must comply with the ambient
environmental requirements defined in Subsection 2.1.3.
3.1.1
Temperature measurement point
When a drive is operating, the ambient temperature measured 3 cm from the base surface of the
optical disk drive and the PCA unit surface must satisfy the environmental requirements
specified in Subsection 2.1.3. For the temperature of each surface during operation, the contact
temperature at each measurement point shown in Figure 3.1 must satisfy the requirements
specified in Subsection 3.1.2.
Low temperature burns:
The surface temperatures of some ICs on the printed circuit board unit
in the optical disk drive exceed 55°C while operating. Be careful of
low tenperature burns.
INSTALLATION REQUIREMENTS
3.1
Environmental Requirements
3.2
Mounting Requirements
3.3
Power supply Requirements
3.4
Connection Requirement
C156-E097-01EN
3 - 1
Hide quick links:
Advertisement
Table of Contents
