Installation Requirements
(2) Setting slave device mode
Figure 3.13 shows the setting for recognizing the slave device (device 1).
(3) Setting cable select mode
Figure 3.14 shows the master device/slave device setting when the CSEL signal is
connected to the interface. In the example shown in Figure 3.15, this setting
requires a special interface connection.
Figure 3.15 shows a cable select example using a special interface cable.
This example connects CSEL of the master device to the CSEL line (conductor) of
the cable, then grounds it so that the drive recognizes that it is the master. At this
time, the CSEL conductor of the slave device is removed and cannot be connected
to CSEL of the cable, so that the drive recognizes that it is the slave.
3-16
CNH5
5
3
6
4
Figure 3.13 Slave device setting
CNH5
5
3
6
4
Figure 3.14 Cable select mode setting
1
2
1
2
C156-E205-01EN