Read-Write Error Recovery Page; Table; Mode Page Format - Fujitsu MCJ3230AP Product Manual

Host Interface
Table 4.50 lists the Mode Page format.
Bit 7
Byte
0 PS
1
2-n

4.6.4.1 Read-Write error recovery page

Bit 7
Byte
0 PS (1)
1
2 AWRE
3
4-7
8
9-11
When the AWRE (Automatic Write Reallocation Enable) bit is 0, no automatic
alternate block assignment is made for the WRITE (10), or WRITE AND VERIFY
command. When the bit of AWRE is 1, automatic alternate block assignment is
made.
When the RC (Read Continuous) bit is 0, the command reports an error if an
uncorrectable data error is detected in the READ (10) command. When the bit of
RC is 1, the command transfers the wrong data and ends normally even if an
uncorrectable error is detected.
When the PER (Post Error) bit is 0, the command reports the GOOD status when it
recovers the normal state by using the error recovery process. When the bit of PER
is 1, the command reports the CHECK CONDITION status when it recovers the
normal state by using the error recovery process. At this time, Sense key is set
with RECOVERED ERROR.
4-46
Table 4.50 Mode Page Format
6 5
0
Page Length (n-1)
Mode Parameters
Table 4.51 Read-Write error recovery page
6 5
0
Page Length (0Ah)
Reserved Reserved
Read Retry Count
Write Retry Count
4 3 2
Page Code
4 3 2
Page Code (01h)
RC Reserved PER
Reserved
00h
1 0
1 0
Reserved DCR
C156-E205-01EN