Ata Commands; Table; Command Codes And Parameters - Fujitsu MCJ3230AP Product Manual

4.5 ATA Commands

Table 4.17 lists supported ATA commands.
This section represents ODD registers as shown below.
Cylinders High/Low registers: CY
Sector register: SC
Device/Head register: DH
Sector Number register: SN
Features register: FR
Protocol Command name
ND CHECK POWER MODE
ND DEVICE RESET
ND EXECUTE DEVICE
DIAGNOSTIC
ND FLUSH CACHE
ND GET MEDIA STATUS
PI IDENTIFY PACKET DEVICE
ND IDLE IMMEDIATE
ND NOP
"
PACKET
ND SET FEATURES
ND SLEEP
ND STANDBY IMMEDIATE
""
RESERVED: Other codes
Notes:
1.
2.
C156-E205-01EN
Table 4.17 Command codes and parameters
Command
E5h
08h
90h
E7h
DAh
A1h
E1h
00h
A0h
EFh
E6h
E0h
y - This register contains parameters effective to run the command.
D - Indicates that only the Device parameter is effective and the LUN
parameter is ineffective.
D* - Device 0 is addressed, but both devices execute the command.
The protocol above indicates the command protocol used.
Parameters used
code
FR SC
y
y y
y y y
y y
4.5 ATA Commands
Section
SN CY DH
D 4.5.1
D 4.5.2
D* 4.5.3
y D 4.5.4
D 4.5.5
D 4.5.6
D 4.5.7
y 4.5.8
y D 4.5.9
D 4.5.10
D 4.5.11
D 4.5.12
4-21