External Operator Panel Setting (Cnh2); Device Type Mode Setting; Scam Mode Setting - Fujitsu MCE3064SS Product Manual

Table 3.6
Signal
CTRGIN
0 V (GND)
3.4.4 External operator panel settings (CNH2)
(1) Device type mode
Table 3.7 shows the device type settings which are returned when the INQUIRY command is
issued to the optical disk drive.
X'07' (Optical memory device)
X'00' (Direct access device)
* Setting when delivered
(2) SCAM mode
Table 3.8 shows the settings which determine whether to use SCAM mode.
The optical disk drive uses SCAM mode.
The optical disk drive does not use SCAM mode.
* : Setting when delivered
External operator panel interface (2 of 2)
Pin Reference
setting
signal
1 – External cartridge sensor output (TTL-IC level)
L level: No cartridge in drive
H level: Cartridge in drive
8, 12, 16 – 0 V
Table 3.7 Device type mode setting
Device Type
Table 3.8

SCAM mode setting

SCAM mode
C156-E097-01EN
Function
CNH 2/Pin 9 - GND
Open*
Shorted
CNH 2/Pin 10 - GND
Shorted
Open*
3 - 25