Setting Data Monitoring Trace Trigger; Trace Control During Executing User Program - Fujitsu SOFTUNE F2 MC-16 User Manual

Start

■ Setting Data Monitoring Trace Trigger

When the debug function on MB2147-01 is set to Trace Enhancement mode, it is possible to set a trace
trigger by a data monitoring condition.
For the data monitoring condition, see the data monitoring break in Section "2.3.4 Break".
Current maximum constant of data monitoring trace triggers
= 8 - (number of data monitoring break settings + number of trace trigger settings +
current number of event settings)
Use the following commands to set the data monitoring trace trigger.
SET TRACETRIGGER/DATAWATCH :
CANCEL TRACETRIGGER/DATAWATCH :
SHOW TRACETRIGGER/DATAWATCH :

■ Trace Control during Executing User Program

In MB2147-01, the trace control is enabled while the user program is executed. However, it is necessary to
end the trace execution.
The parameter that can be controlled is as follows;
• Set trace trigger
• Set filtering area
• Display trace data
• Clear trace data
• Search trace data
• Set trace delay
• Display measurement result of time
• Forced termination/resumption of trace execution
*: Only when the debugging is in trace enhancement mode.
Notes:
• The trace execution means the trace data acquisition is "Tracing" or "Pause".
• The following method exists to terminate the trace execution.
1. Forced termination of trace execution
- Trace window - Shortcut menu [Forced termination]
- Trace toolbar [Forced termination] button
2. Trace trigger (Termination)
- SET TRACETRIGGER command
- Trace trigger setting dialog
Figure 2.3-3 Trace Sampling Operation (Trace Trigger)
Resume Resume
Suspend
*
CHAPTER 2 DEPENDENCE FUNCTIONS
Resume
Suspend Suspend
Program flow
Trace buffer
Sets a data monitoring trace trigger
Deletes a data monitoring trace trigger
Displays a data monitoring trace trigger
*
*
169