FujiFilm FinePix Z100fd Owner's Manual page 142

Troubleshooting
Matters
Cannot use the
flash.
Flash
The flash settings
are restricted and
cannot be
selected.
The playback
image is dark
even though the
flash was used.
The image is
blurred.
Photographed images
There is speckling
on the image.
142
Problems Possible causes
The shutter button was pressed while the
flash was charging.
The Shooting mode is set to
or .
The battery has run out.
Continuous shooting is selected.
The flash mode is set to C.
Silent mode is set.
The Shooting mode is set to AUTO,
, ,, ., /,
, , or
Silent mode is set.
The subject is too far away.
Your finger was covering the flash.
The lens is dirty.
AF frame (lit red) and { appeared when
taking pictures.
appeared when taking pictures.
The picture was taken with a slow shutter
speed (long exposure) in a high-
temperature environment.
, ,,
,
,
, , , , , ,
.
Solutions
Wait until the charging is completed before
pressing the shutter button.
Change the Shooting mode.
Charge the battery or load fully charged
battery.
Set continuous shooting to OFF.
Set the flash mode to something other
than C.
Release Silent mode.
The flash settings are restricted because
the camera settings are tailored to the
scene being shot. Change the Shooting
mode for a wider range of flash settings.
Release Silent mode.
Move to within the effective flash range
before taking the picture.
Hold the camera correctly.
Clean the lens.
Check the focus on the subject and take
pictures.
It may cause camera shake. Hold the
camera steadily.
This is a characteristic of CCDs and does
not indicate a camera fault.
Page
62
53
14, 16
70
61
26
53
26
59, 62
28
29,
134
30,
134
–