To Prepare For Software Installation - HP OmniBook 6100 - Notebook PC Manual

Important
Installing Retail Windows 98 Second Edition or Windows 98
Before installing Windows 98, please install the latest BIOS for your HP notebook.
To check your BIOS version do the following:
1. Start the HP notebook.
2. Press F2 to enter Setup when prompted.
3. Check the BIOS version in the upper left corner.
You can download the latest HP notebook BIOS from http://www.hp.com/go/support.

To prepare for software installation

Create a support utility disk for use during installation. You will need a computer with a
working Windows operating system to make a support utility disk.
1. Insert the Recovery CD in the CD-ROM drive.
2. Open the MS-DOS Prompt.
3. Go to the \HP\BOOTDISK directory on the Recovery CD. If D: is the drive letter of
your CD-ROM drive, type:
D:CD\HP\BOOTDISK
4. Type MAKESUPP.
5. When asked to select a floppy drive, type A.
6. Type Y to acknowledge warning and continue.
7. Insert a blank floppy disk in the A: drive and press any key to continue.
8. When copy is complete, type N when asked: "Would you like to copy another disk
(Y/N)".
9. Close the MS-DOS Prompt.
HP recommends that you repartition and format your hard disk before installing retail
Windows 98 Second Edition. Follow the instructions below to partition your hard disk
and create the hibernation partition.
1. Insert the bootable Recovery CD-ROM in the CD-ROM drive.
2. Boot the HP notebook, press ESC and select the CD-ROM/DVD as the boot device.
3. Click "Continue" on the Recovery screen to enter the menu.
Using Windows 98
Corporate Evaluator's Guide 123