To Install Intel® Speedstep™ Technology Applet - HP OmniBook 6100 - Notebook PC Manual

3. Use the down arrows to highlight the Infrared Port.
4. Press Enter and select Enabled. The other settings are fine at default values.
Default Values:
Mode: FIR
Base I/O: 2F8
Interrupt: IRQ 3
DMA Channel: DMA 0
5. Press F10 to save and exit Setup, select Yes to confirm. This will reboot the system,
when Windows 2000 finishes booting it will discover the new hardware and start the
Add Hardware Wizard.
6. At the Wizard welcome screen, click Next.
7. Select Search for Driver, and click Next.
8. Select Specify Location, and click Next.
9. Enter D:\HP\DRIVERS\FIR into the search path. This assumes D: as the CD-ROM
containing the Recovery CD.
10. The wizard will find a driver for the infrared device, follow the remainder of onscreen
directions to complete installation.
To install Intel® SpeedStep™ Technology Applet
If you have installed retail Windows you need to install the Intel SpeedStep driver. The
driver is contained in the \HP\DRIVERS\SPEEDSTP subdirectory on the Recovery CD.
To install or upgrade the Intel SpeedStep driver:
1. Run SETUP.EXE from the driver directory on your Recovery CD
(\HP\DRIVERS\SPEEDSTP).
2. Follow the onscreen directions to complete installation.
Upon successful completion you will be asked to reboot your computer, choose "Yes, I
want to restart my computer now" if you have no other drivers to install. Otherwise,
choose "No, I will restart my computer later" and continue to next step.
Using Windows 2000
Installing Retail Windows 2000
Corporate Evaluator's Guide 115