Troubleshooting - FujiFilm FinePix A201 Owner's Manual

Warning Displays
eThe table below lists the warnings that are displayed on the LCD monitor
Warning Displayed
The playback frame number has
reached 999–9999.
i The data could not be recorded
due to a SmartMedia error or a
connection error between the
SmartMedia and camera.
i The photographed image cannot
be recorded as it is too large to fit
in the available space on the
SmartMedia.
There is a strong likelihood of
camera shake because the shutter
speed is slow.
A protected frame was erased.
DPOF settings are specified for an
image you tried to erase.
Prints were specified for more than
1000 frames in the DPOF frame
settings.
74
Explanation Remedy
Take the shot using a formatted SmartMedia.
i Re-insert the SmartMedia or switch the
camera off and then on again.
i Use a new SmartMedia.
Use flash photography. However, a tripod
should be used for some scenes and modes.
Protected files cannot be erased. Unprotect the
frame using the camera on which the protection
was first applied.
To erase the image, specify "RESET" as the
DPOF setting (➡P.50).
The maximum number of frames for which
prints can be specified on the same
SmartMedia is 999.

Troubleshooting

Problem Cause
No power.
iThe battery is exhausted.
iThe AC power adapter plug has come out
of the power outlet.
Power cuts out during iThe battery is exhausted.
operation.
Battery runs out quickly.
iYou are using the camera in extremely
cold conditions.
iThe terminals are soiled.
iThe battery is flat.
No photograph is taken iNo SmartMedia is loaded.
when the shutter button iThe SmartMedia is fully recorded.
is pressed.
iThe SmartMedia is write-protected.
iThe SmartMedia is not formatted.
iThe SmartMedia contact area is soiled.
iThe SmartMedia is damaged.
iThe Power Save function has switched the
camera off.
iThe battery is exhausted.
eIf you think the camera is faulty, check the following once more
Remedy
iReplace the batteries.
iPlug the adapter back in.
iReplace the batteries.
iPut the battery in your pocket or another
warm place to heat it and then load it into
the camera just before you take a picture.
iWipe the battery terminals with a clean,
dry cloth.
iPurchase new batteries.
iLoad a SmartMedia.
iInsert a new SmartMedia or erase some
unwanted frames.
iRemove the write-protection.
iFormat the SmartMedia.
iWipe the SmartMedia contact area with a
clean dry cloth.
iLoad a new SmartMedia.
iSwitch the camera on.
iPurchase new batteries.
75