When An Error Message Appears - Canon imageCLASS MF4880dw Settings Manual

• You should press the WPS button within 2
minutes after you select <Yes> in step
• Press and hold* the button until the lamp lights
or blinks.
* The time that you should hold the button may vary
depending on the router you are using.
Move to the machine
• After the <Connected.> screen is displayed,
wait until the Wi-Fi indicator stops blinking and
turns on.
Wait approximately 2 minutes
after the connection is completed.
The IP address is set during this time period.
Proceed to P.9
1
Prepare for Wireless LAN Connection

When an error message appears:

Press [OK] to close the screen, check whether or
not the network key is correct, and then retry the
settings.
If the access point cannot be detected even after
retrying, see the following.
.
When checking the network connection:
You can check if the machine is properly connected
to the network using a computer that is connected
to a network.
When setting an IP address manually:
2
Setting the Wireless LAN
Setting the Wireless LAN
"When an Error Message Appears" (P.14)
"Checking that the Wireless LAN Setting is
Completed" (P.9)
"Setting by Manually Entering SSID" in the
e-Manual
3 4
Installing the Software
5
Troubleshooting