Number Of Available Frames; I Standard Number Of Frames Per Xd-Picture Card - FujiFilm FinePix A205 Owner's Manual

SHOOTING STILL IMAGES (
STILL PHOTOGRAPHY MODE
7
8
Beep
I Viewfinder Lamp Display
Display
Lit green Ready to shoot
Blinking green AF/AE in progress, camera shake warning or AF warning (Ready to shoot)
Blinking green and Recording to xD-Picture Card (Ready to shoot)
orange alternately
Lit orange Recording to xD-Picture Card (Not ready)
Blinking orange Flash charging (Flash will not fire)
Blinking green Camera in Power Save mode (➡P.47)
(1-second intervals)
Blinking red h xD-Picture Card Warnings
No card loaded, card not formatted, incorrect format, card full, xD-Picture Card error
h Lens operation error
✽ When the LCD monitor is switched on, more detailed warning messages are displayed (➡P.72-73).
N
Subjects Not Suitable for Autofocus
Though the FinePix A205/FinePix A210 uses an accurate autofocus mechanism, it may have difficulty
focusing or not be able to focus at all for the types of subjects and situations listed below. In such
cases, the image may be out of focus.
h Very shiny subjects such as a mirror or car body
h Subjects photographed through glass
h Subjects that do not reflect well, such as hair or fur
h Subjects with no substance, such as smoke or
flames
h When the subject is dark
h When there is very little contrast between the
subject and the background (such as white walls
or subjects dressed in the same color as the
background)
20
AUTO MODE )
Press the Shutter button down halfway. Focusing is
complete when the AF frame on the LCD monitor
shrinks and the viewfinder lamp (green) stops
blinking and remains lit.
G
!
If " " appears on the LCD monitor, the camera cannot focus.
G
!
Pressing the shutter button down halfway, the image on the
LCD monitor freezes briefly. However, this is not the recorded
image.
G
!
If " " appears on the LCD monitor, (e.g. the shot is too dark
for the camera to focus), try standing about 2 m (6.6 ft.) from
your subject to take the picture.
To take the picture, press the Shutter button down
fully without lifting your finger off it. The camera beeps
and takes the picture, and the data is then recorded.
G
!
There is a slight delay between the Shutter button being
pressed and the shot being taken. If necessary, play back the
shot to check the image.
G
!
Pressing the Shutter button down fully in one motion, the shot
is taken without the AF frame changing.
G
!
When you take the shot, the viewfinder lamp lights orange
(shooting disabled). The viewfinder lamp then changes to
green to indicate that the next picture can be taken.
G
!
The viewfinder lamp blinks orange while the flash is charging.
If the LCD monitor is switched on, the screen goes dark. This
is normal and does not indicate a fault.
G
!
See P.72-73 for information on the warning displays.
Status
N
h Subjects moving at high speed
h When something other than your subject is close
to the AF frame, has contrasting areas of light and
dark and is either closer or further away than your
subject (as when you photograph someone
against a background with strongly contrasting
elements)
For subjects of this type, use AF/AE lock (➡P.22).

NUMBER OF AVAILABLE FRAMES

I Standard number of frames per xD-Picture Card

The table below shows the standard number of available frames for a new xD-Picture Card formatted on the camera. The
larger the xD-Picture Card capacity, the greater the divergence between the actual number of available frames and the
number shown here. Also, because the amount of data recorded for a shot varies depending on the subject, in some cases
the number of shots may decrease by 2 or may remain the same. As a result, the actual number of recordable shots may
either decrease or increase.
FinePix A205
Quality mode 2M
1600 × 1200
Number of recorded pixels
DPC-16 (16 MB) 25
DPC-32 (32 MB) 50
DPC-64 (64 MB) 101
DPC-128 (128 MB) 204
DPC-256 (256 MB) 409
FinePix A210
Quality mode 3M
2048 × 1536
Number of recorded pixels
DPC-16 (16 MB) 19
DPC-32 (32 MB) 40
DPC-64 (64 MB) 81
DPC-128 (128 MB) 162
DPC-256 (256 MB) 325
The number of available frames in this card is
displayed on the screen.
G
!
See P.30 for information on changing the quality mode.
G
!
The default quality mode " " set at shipment is .
1M 0.3M
1280 × 960 640 × 480
33 122
68 247
137 497
275 997
550 1997
2M 1M 0.3M
1600 × 1200 1280 × 960 640 × 480
25 33 122
50 68 247
101 137 497
204 275 997
409 550 1997
21