I Indicator Lamp Display; Number Of Available Frames; I Standard Number Of Frames Per Xd-Picture Card - FujiFilm Finepix S5000 Owner's Manual

TAKING PICTURES ( AUTO MODE )
STILL PHOTOGRAPHY MODE
9
AF frame
10
Bebeep
11
Click
22
Frame the shot so that the subject fills the entire AF
(Auto Focus) frame.
G
!
If the subject is not in the AF frame, use AF/AE lock to take
the picture (➡P.24).
When you press the Shutter button down halfway,
the camera emits a short double-beep and focuses
on your subject. At that point, the AF frame on the
screen becomes smaller and the camera sets the
shutter speed and aperture (the indicator lamp
(green) changes from blinking to steady).
G
!
The image shown on the screen before you take the shot
may differ in its brightness, color, etc. from the image actually
recorded. If necessary, play back the recorded image to
check it (➡P.27).
G
!
For subjects with no clear contrast between dark and light,
the camera may not give a short double-beep when the AF
frame becomes smaller. However, the shot is still in focus.
G
!
If the camera does not emit a short double-beep and "
appears on the screen, the camera cannot focus.
G
!
When you press the Shutter button down halfway, the image
on the screen freezes temporarily. However, this image is not
the recorded image.
G
!
If " " is displayed on the screen, try standing about 2 m
(6.6 ft.) from your subject to take the picture.
If you press the Shutter button down fully without
releasing it, the camera makes a clicking noise and
takes the picture. The camera then records the
photographed image.
G
!
There is a slight delay between the Shutter button being
pressed and the shot being taken. If necessary, playback the
shot to check the image.
G
!
If you press the Shutter button down fully in one motion, the
shot is taken without the AF frame changing.
G
!
When you take the shot, the indicator lamp lights orange
(shooting disabled). The indicator lamp then changes to
green to indicate that the next picture can be taken.
G
!
The indicator lamp blinks orange while the flash is charging.
The monitor may go dark briefly. This is normal and does not
indicate a fault.
G
!
See P.101-102 for information on the warning displays.

I Indicator lamp display

Display
Lit green Ready to shoot.
Blinking green AF/AE in progress, camera shake warning or AF warning (Ready to shoot).
Blinking green and Recording to xD-Picture Card (Ready to shoot).
orange alternately
Lit orange Recording to xD-Picture Card (Not ready).
Blinking orange Charging the flash (flash will not fire).
Flashing green Camera in Power save mode (➡P.75).
(1-second intervals)
i xD-Picture Card Warnings
Blinking red
i Lens operation error.
N
Subjects not suitable for autofocus
Though the FinePix S5000 uses an accurate autofocus mechanism, it may have difficulty focusing or
not be able to focus at all on the types of subjects and situations listed below. In such cases, the image
may be out of focus.
h Very shiny subjects such as a mirror or car
body.
h Subjects photographed through glass.
"
h Subjects that do not reflect well, such as hair or
fur.
h Subjects with no substance, such as smoke or
flames.
h When the subject is dark.
h When there is very little contrast between the
subject and the background (such as white

NUMBER OF AVAILABLE FRAMES

I Standard number of frames per xD-Picture Card

The table below shows the standard number of available frames for a new xD-Picture Card formatted on the camera. The
larger the xD-Picture Card capacity, the greater the divergence between the actual number of available frames and the
number shown here. Also, because the amount of data recorded varies depending on the subject, the number of available
frames may not decrease or may decrease by 2 when a frame is taken. Consequently, the actual number of available frames
may be more or less than what is displayed.
Quality mode
Number of recorded pixels
DPC-16 (16 MB)
DPC-32 (32 MB)
DPC-64 (64 MB)
DPC-128 (128 MB)
DPC-256 (256 MB)
DPC-512 (512 MB)
Status
No card loaded, card not formatted, incorrect format, card full, xD-Picture Card error.
✽ Detailed warning messages are displayed on the monitor (➡P.101-102).
N
walls or subjects dressed in the same color as
the background).
h Subjects moving at high speed.
h When there is a high-contrast subject other than
the main subject at or near the center of the
image and that subject is closer to or further
from the camera than the main subject (as when
you photograph someone against a background
with strongly contrasting elements).
For subjects of this type, use AF/AE lock (➡P.24).
The number of available frames is displayed on the
screen.
G
!
See P.30 for information on changing the Quality mode.
G
!
The default Quality mode " " set at shipment is
2816 × 2120 2048 × 1536 1600 × 1200
10 19 25
21 40 50
43 81 101
86 162 204
173 325 409
347 651 818
.
CCD-RAW
1280 × 960 2816 × 2120
33 2
68 4
137 9
275 18
550 37
23
1101 75