Honda 2010 Insight Owner's Manual page 170

To Play the FM/AM Radio
The ignition switch must be in the
ACCESSORY (I) or ON (II) position.
Turn the system on by pushing the
FM/AM button. Adjust the volume
by turning the VOL/SELECT knob.
The band and frequency that the
radio was last tuned to are displayed.
To change bands, press the FM/AM
button. On the FM band, ST will be
displayed if the station is
broadcasting in stereo. Stereo
reproduction in AM is not available.
To Select a Station
You can use any of five methods to
find radio stations on the selected
band: tune, seek, scan, the preset
buttons, and auto select.
Playing the FM/AM Radio (Models without navigation system)
TUNE Use the SEEK button to
tune to a desired frequency. Press
the button to tune to a higher
frequency, and the
tune to a lower frequency.
You can also operate the tune
function by using the VOL/SELECT
knob. Press the VOL/SELECT knob
and you will see ''SEL'' in the display.
Turn the knob right to tune to a
higher frequency, or left to tune to a
lower frequency. To turn it off, press
the VOL/SELECT knob or
button, or
The system will return to the normal
display about 10 seconds after you
stop adjusting the tune mode.
2010 Insight
SEEK
searches up and down from the
current frequency to find a station
button to
with a strong signal. To activate it,
press and hold the
of the SEEK button until you hear a
beep, then release it.
SCAN
all stations with strong signals on the
selected band. To activate it, press
the SCAN button, then release it.
You will see SCAN in the display.
When the system finds a strong
button. signal, it will stop and play that
station for about 10 seconds.
If you do nothing, the system will
then scan for the next strong station
and play it for 10 seconds. When it
plays a station you want to listen to,
press the SCAN button again.
The SEEK function
or side
The scan function samples
CONTINUED
167