Viper 5900 Owner's Manual page 44

vehicle, one for each user.
note: Owner Recognition cannot be programmed with-
out a Bitwriter
your dealer for more information.
r r a a p p i i d d r r e e s s u u m m e e l l o o g g i i c c
This Directed system will store its current state to non-volatile
memory. If power is lost and then reconnected the system will
recall the stored state from memory. This means if the unit is in
Valet Mode and the battery is disconnected for any reason, such
®
as servicing the car, when the battery is reconnected the unit will
still be in Valet
including arm, disarm, and Valet
p p o o w w e e r r s s a a v v e e r r m m o o d d e e
Your system will automatically enter Power Saver Mode while
armed or in Valet
operation has been performed. This lowers the current draw on
the vehicle's battery. Power Saver Mode takes over under the
following conditions:
➤
Power Saver when the system is armed: After the system has
been armed for 24 hours the LED will flash at half its
normal rate, decreasing the system's current draw.
40
and the necessary software. Check with
®
Mode. This applies to all states of the system
®
Mode, after a period of time in which no
®
Mode.
®
© 2006 directed electronics