Table of Contents
Advertisement
A
DVANCED
Using On-Screen Display
You can display the VCR operating status on the
TV screen.
For the information about what you can see on
the TV screen, see page 4.
1
Select VCR Set Up Mode
1 Press VCR.
2 Press MENU.
5
3 Press PLAY
or STOP
to select"VCR SET UP"
then press OK/STATUS.
The VCR Set Up menu appears.
2
Select On-Screen Mode
5
1 Press PLAY
or STOP
SCREEN MODE."
3
2 Press FF
.Each time you press the button, the
setting changes.
ON:
When you press a tape running button (Stop,
Play, etc.), the VCR status appears for 5
seconds.
COUNTER:
When you press a tape running button, the
VCR operating status appears for 5 seconds.
After 5 seconds, the VCR status disappears
except the time counter.
OFF:
The VCR operating status does not appear
even if you press a tape running button.
3
Finish Setting
Press MENU.
To display the VCR status on the TV screen
manually, press OK/STATUS. The VCR status
appears for about 5 seconds.
• If "ON SCREEN MODE" is set to OFF," no VCR
status appears though you press OK/STATUS.
SmartPicture
You can make the picture softer, sharper or
distinct the picture when playing back the tape.
SmartPicture is set to AUTO when you receive
the VCR.
1
Select SmartPicture Mode
1 Press VCR.
2 Press SMARTPICTURE button.
The current setting will appear on the screen
for about 5 seconds.
220/75
O
PERATIONS
3 While the current setting
DSPC
ON
∞
ON SCREEN MODE
ON
TIMER REC SPEED
MANUAL
SELECT:
CHANGE:
END: MENU
∞
to select "ON
Notes:
• It is recommended that the SmartPicture is set to
• When "DSPC" is set to "OFF", "AUTO" is
Auto tracking
Each time a tape is inserted, auto tracking starts
working and continuously analyses the signal to
adjust for optimum picture quality during
playback. So, there is no need for you to
minimize noises in most tapes during playback.
Manual tracking
• During normal playback:
• During a slow motion picture:
• During a still picture:
To cancel manual tracking, stop the tape, eject
the tape, then re-insert it.
Notes:
If you keep pressing CH
"USE CLEANING CASSETTE" message on the screen.
Please disregard this message and re-adjust the
tracking. However, if the message appears
automatically (without pressing CH
indicates that your video heads are dirty. ( P.24)
— 14—
14
(
CONTINUED
appears, press the SMART
PICTURE button repeat-
edly, the setting changes as
follows.
AUTO:
Normally select this mode.
DISTINCT:
Select this mode when you want the distinct
picture. The picture detail is emphasized.
SOFT:
Select this mode when you want the soft
picture. The signal noise of the picture is
softened.
SHARP:
Select this mode when you want the sharp
picture. The picture edge is emphasized.
"SOFT" if playback picture is noisy.
switched to "NATURAL" automatically.
Tracking Adjustment
If auto tracking cannot eliminate noises well
during playback, press CH
5
∞
Press CH
or
to minimize noises in the
slow motion picture.
5
∞
Press CH
or
to
reduce jitter in the still
picture.
5
∞
/
01.5.11, 4:16 PM
)
AUTO
5
∞
or
.
button, you might get
5
∞
/
), this
Advertisement
Table of Contents
