Table of Contents
Advertisement
S
U
ETTING
Setting the Video Channel
This VCR is designed to send picture and sound signal on UHF channel 38(597.25 MHz) to the TV,
through the RF coaxial cable.
For customers in Australia;
If you want to change this video channel (38) to another channel (between 28 to 60), follow the
procedure below before turning on the VCR for the first time.
For customers in New Zealand;
Be sure to set video channel (between 28 to 60) by following the procedure below before turning on
the VCR for the first time.
1 Make sure the VCR is turned off and no cassette is inserted.
2 Turn on the TV, and tune it to any channel (UHF 28 to 60) you want to use as the video channel
on the TV.
• Select a channel not used in your area.
3 Press STOP/EJECT
The following indication appears on the display.
TV system number starts flashing.
5
4 Press CHANNEL
area.
1. For B/G. (For West Europe, ASEAN countries, New Zealand)
2. For D/K. (For China, Russia, East Europe)
3. For I. (For Hong Kong, South Africa, United Kingdom)
4. For H. (For Australia)
5 Press OK/STATUS.
The channel number starts flashing on the display.
Channel number starts flashing.
5
6 Press CHANNEL
video channel in step 2.
A test signal (two vertical white bars)
appears on the TV.
Test signal
(two vertical white
bars)
7 Press OK/STATUS to finish the video channel setting.
Now you will enter the Clock Setting mode explained on page 9.
To watch a picture from this VCR on the TV, select the same channel you have selected as the
video channel (in step 2 above) on the TV.
Note: This VCR is factory pretuned to capital city stations 2, 7, 9, 10, and 28.
220/75
P
7
0
/
on the front panel for more than 5 seconds.
∞
/
on the front panel to select an appropriate TV system number for your
∞
/
on the front panel to select the channel you have tuned on the TV as the
If you use only external video input (AV) mode to
watch the picture from this VCR:
You can turn off the video channel output. To turn off
the video output channel, press CH
appears on the channel number position.
— 8 —
8
∞
until "– –"
01.5.11, 4:16 PM
Advertisement
Table of Contents
