Mechanical Installation - Raytheon SC125VNV Installation & Maintenance

Mechanical Installation

Note: Improper installation may void the
warranty. Consult the manufacturer or your
distributor before deviating from the
following procedures.
A bolt kit consisting of eight bolts is available
as an option. All machines use 3/4–10 x 8"
bolts. The bolts should be embedded in a 3500
psi minimum reinforced concrete floor that is a
minimum of 12 inches (304 mm) thick. Use
the mounting bolt layout in Figure 2–3. (The
front of the washer-extractor is the bottom of
each diagram.)
Figure 2–3
The threaded end of the bolts should extend
two inches above the surface of the floor.
F232097R1
See Figure 2–4 for a typical installation of
individual mounting bolts.
A bolt-locator fixture or rebar frame is
available as an option. This rigid welded
assembly made of reinforcing rod and
mounting bolts is designed to be embedded
in concrete. See Figure 2–5.
Machine Base
Mounting
Bolt Threads
Grouting
MI003K
Reinforcing
Rod
2–11
Installation
Frame
Grout
P010I1A
Figure 2–4
P011I1A
Figure 2–5