Table of Contents
Advertisement
2-3
Integrated Peripherals
CMOS Setup Utility-Copyright (C) 1984-2004 Award Software
On-Chip Primary PCI IDE
On-Chip Secondary PCI IDE
IDE1 Conductor Cable
IDE2 Conductor Cable
USB Controller
USB Keyboard Support
USB Mouse Support
AC97 Audio
Onboard H/W LAN
Onboard Serial Port 1
Onboard Serial Port 2
UART Mode Select
x UR2 Duplex Mode
Onboard Parallel Port
Parallel Port Mode
x ECP Mode Use DMA
Game Port Address
Midi Port Address
x Midi Port IRQ
higf: Move
Enter: Select
F5: Previous Values
On-Chip Primary PCI IDE
Enabled
Disabled
On-Chip Secondary PCI IDE
Enabled
Disabled
IDE1 Conductor Cable
Auto
ATA66/100
ATA33
IDE2 Conductor Cable
Auto
ATA66/100
ATA33
USB Controller
Enabled
Disabled
GA-8GEM800 Motherboard
Integrated Peripherals
[Enabled]
[Enabled
[Auto]
[Auto]
[Enabled]
[Disabled]
[Disabled]
[Auto]
[Enabled]
[3F8/IRQ4]
[2F8/IRQ3]
[Norm al]
[Half]
[378/IRQ7]
[SPP]
3
[201]
[Disabled]
10
+/-/PU/PD: Value
F6: Fail-Safe Defaults
Enable onboard 1st channel IDE port. (Default value)
Disable onboard 1st channel IDE port.
Enable onboard 2nd channel IDE port. (Default value)
Disable onboard 2nd channel IDE port.
BIOS autodetects IDE1 conductor cable .(Default Value)
Set IDE1 Conductor Cable to ATA66/100/133 (Please make sure your
IDE device and cable are compatible with ATA66/100).
Set IDE1 Conductor Cable to ATA33. (Please make sure your IDE
device and cable are compatible with ATA33)
BIOS autodetects IDE2 conductor cable. (Default Value)
Set IDE2 Conductor Cable to ATA66/100/133. (Please make sure your
IDE device and cable are compatible with ATA66/100)
Set IDE2 Conductor Cable to ATA33. (Please make sure your IDE
device and cable are compatible with ATA33)
Enable USB Controller. (Default value)
Disable USB Controller.
- 36 -
Item Help
Menu Level }
If a hard disk
controller card is
used, set at Disabled
[Enabled]
Enable onboard IDE
PORT
[Disabled]
Disable onboard IDE
PORT
F10: Save
ESC: Exit
F7: Optimized Defaults
F1: General Help
Advertisement
Table of Contents
