If The Monitor Ports Are A 5Bnc Ports - Epson EMP-7800 User Manual

Connecting to a Computer

If the Monitor Ports are a 5BNC Ports

Either of the following two connection methods can be used depending on
the connection ports or the type of cable being used.
• Use the optional VGA-HD15/BNC PC cable to connect the monitor port
of the computer to the [Computer] port at the rear of the projector.
See "Appendices: Optional Accessories"
• Use a commercially-available 5BNC monitor cable
to connect the monitor ports of the computer to the [BNC] port at the rear
of the projector.
If connecting to the [Computer] port
To monitor ports
VGA-HD15/BNC PC cable
(optional)
p.135
(5BNC /male-male)
To [Computer] port (blue)
TIP
• After projection starts, change the "Computer Input" setting in the
"Setting" menu to "Analog-RGB".
• If more than one external component is connected to the projector,
press the [Comp] button on the remote control after projection starts,
or repeatedly press the [Computer/DVI] button on the projector's
control panel until "Computer (Analog-RGB)" is displayed on the
projected image to select the signal to be projected.
20
p.83
p.35