What To Do If - Electrolux EHS 6691 Installation And Operating Instructions Manual

What to do if ...

Problem
The cooking zones will not switch
on or are not functioning
The residual heat indicator is not
displaying anything
The automatic warm up function is
not switching itself on
Acoustic signal sounds and appli-
ance switches itself on and then off
again; after 5 seconds another
acoustic signal sounds
_
is lit
e
and number are displayed
16
Possible cause
More than 10 seconds have passed
since the appliance was switched
on
The child safety device is switched
l
on
Several sensor fields were touched
at the same time
The sensor fields are partly covered
by a damp cloth or with liquid
Safety cut-out has been triggered
The lock is switched on
The cooking zone was only on for a
short time and is therefore not hot
There is still residual heat on the
cooking zone h
The highest heat setting is set Ç
The heat setting was set using the
sensor field
The On/Off sensor field has been
covered up, e.g. by a cloth
Overheating protection for the
cooking zone has been triggered
Electronics fault
Switch the appliance on again.
Deactivate the child safety device
(See the section "Child safety de-
vice")
Only touch one sensor field
Remove the cloth or the liquid.
Switch the appliance on again.
Switch the appliance on again
l
Switch off the lock (See the section
"Locking/unlocking the control
panel")
If the cooking zone is supposed to
be hot, call your local Service Force
Centre.
Let the cooking zone cool down
The highest heat setting has the
same power as the automatic warm
up function
1.Switching off the cooking zone
1.Set the cooking zone using the
sensor field
Do not place any objects on the
control panel
Switch off the cooking zone.
Switch the cooking zone on again
Disconnect the appliance from the
electrical supply for a few minutes
(Take the fuse out of the house's
wiring system)
If after switching on again,
played again, call the customer
service department
Remedy
e
is dis-