Prepare The Door For Installation - Pella 81CM0100 Installation Instructions Manual

2
OPENING PREPARATION (CONTINUED)
O. Cut two pieces of flashing
tape 12" longer than the
rough opening width. Place
tape #1 across the sill nosing
just up to where the nosing
begins to slope down and
extending 6" up each jamb.
Apply the second piece of
flashing tape over-lapping
the first piece and the exterior
edge of the sill pan and 6" up
each jamb.
3

PREPARE THE DOOR FOR INSTALLATION

A.
Note: If screens, grilles or hardware are removed from the door at this time, label them
and store them in a protected area.
B.
remove the spacers from both the top and bottom of the movable panel.
C.
panel away from the door frame. Then, lower the panel out of the top track. Carefully set
the panel aside.
D.
of the door lock jamb and fixed jamb in the locations shown. Space the holes a maximum
of 6" from each end and a maximum of 10" on center.
FIXED JAMB
E.
at each indentation in the extrusion at the
top (head) of the door frame.
Carefully slide the movable panel halfway open and
by lifting it off of the lower track and tilting the bottom of the
EXTERIOR
2D
3D
Drill 13/64" clearance holes
through frame at 45° angle
2O
SILL TAPES
through the frame at a 45° angle, on the room side
VENT JAMB
INTERIOR
Sill Pan
2O
6" MAX
10" MAX
10" MAX
10" MAX
10" MAX
10" MAX
10" MAX
10" MAX
6" MAX
Sill Nose
Sill Nose