Cle An Ing; Cleaning The Glass; Spot-Cleaning Stubborn Materials On All Glass; Cleaning The Door Panel - Pella architect series Owner's Manual

Architect series ® , Pella ® and encompass by Pella
c L e A n i n G
c LeAni nG tHe GLAss
To wash the glass:
1. Use a premixed vinegar-based cleaning solution (or make your own with one part white vinegar to 10 parts water), and apply to a soft,
clean, lint-free microfiber cloth or paper towel. Or you may use an ammonia-free glass cleaner such as Windex
(purple liquid). Feel free to be generous with the amount of cleaner you apply, but avoid getting any cleaning solution on the door
panel as it may discolor the finish.
2. Rub from several different directions.
3. Rinse with clear water if streaks remain after cleaning.
cAUtion: do not use glass cleaners that are ammonia- or alcohol-based. they may leave streaks or produce a film that attracts moisture or dust.
s Pot-c Le Anin G st Ubborn m Ateri ALs on ALL GLA s s
To remove any markings from grease, oil, tape adhesive, crayons or paint, or marks from plastics that may have come in contact with the glass:
1. Apply a small amount of a nonabrasive cleaner such as Bar Keepers Friend
solvent such as acetone or mineral spirits to a clean, dry, lint-free microfiber cloth or paper towel.
2. Rub on the areas of glass that need spot-cleaning. Avoid getting any cleanser or solvent on the door panel as it may discolor the finish.
3. Wipe clean using a clean, dry, lint-free microfiber cloth or paper towel.
4. Then clean the glass as instructed above.
cAUtion: do not use a razor blade to scrape off stubborn materials — doing so may leave permanent marks on the glass or
scratches that could cause glass breakage. contact the Pella window and door showroom nearest you for special cleaning
instructions.
c LeAni nG tHe d oor PAneL
A warm, damp cloth and mild soap may be used on all Pella
cL eAni nG tH e exte rior A LU min Um c LA ddinG
Clean the surface with warm, soapy water. Stubborn stains and deposits may be removed with mineral spirits. If your cladding becomes dull,
you can use a quality car cleaner and wax to restore the shine. Should you need it, touch-up paint is available at the Pella Window and Door
Showroom nearest you.
cAUtion: do not use abrasive or caustic solvents as they may damage your entry door. do not scrape or use tools that might damage the surface.
do not power-wash.
cL eAni nG HArdwAre finis Hes
A soft cloth and mild cleaner may be used on most hardware finishes for entry doors from Pella.
3.1
® entry door owner's manual
(SerVaas Laboratories) to a clean, wet cloth — or apply a
®
® fiberglass or steel entry door panels.
Cleaning
® (clear liquid) or Sparkle ®