Capacitance Measurement - UNI-T UT60A Operating Manual

Model UT60A: OPERATING MANUAL
Measurement Operation (6)
3. Connect the test leads across with the object being
measured.
The measured value shows on the display.
Note
l
The test leads can add 0.1 to 0.2 of error to
resistance measurement. To obtain precision
readings in low-resistance measurement, that is the
range of 400.0 , short-circuit the input terminals
beforehand, using the relative value function button
REL
when the testing leads are short-circuited from the
reading.
l
For high-resistance measurement (>1M ), it is
normal taking several seconds to obtain a stable
reading.
l
If reading with shorted test leads is not 0.5 ,
check for loose test leads, incorrect function selection,
or enabled Data Hold function.
l
The LCD displays
tested resistor or the resistor value is higher than
the maximum range of the Meter.
l
When resistance measurement has been completed,
disconnect the connection between the testing leads
and the circuit under test.
C. Capacitance Measurement
to automatically subtract the value measured
indicating open-circuit for the
24
(see figure 8)
red black
(figure 8)