TYAN Tiger K8W S2875 User Manual page 29

The Tiger K8W is also equipped with 4 Serial ATA (SATA) channels.
Connections for these drives are also very simple.
There is no need to set Master/Slave jumpers on SATA drives.
Tyan has supplied two SATA cables and one SATA power adapter. If you are in need
of other cables or power adapters please contact your place of purchase.
The following pictures illustrate how to connect an SATA drive
Floppy Drives
Attaching floppy diskette drives are done in a similar manner to hard drives. See the
picture below for an example of a floppy cable. Most of the current floppy drives on
the market require that the cable be installed with the colored stripe positioned next to
the power connec tor. In most cases, there will be a key pin on the cable which will
force a proper connection of the cable.
1. SATA drive cable connection
2. SATA drive power connection
3. SATA cable motherboard
connector
4. SATA drive power adapter
29
http://www.TYAN.com
Attach first floppy drive
(drive A:) to the end of the
cable with the twist in it.
Drive B: is usually
connected to the next
possible connector on the
cable (the second or third
connector after you install
Drive A:).