When wrapping, the laminating cover should overlap the printed part sufficiently. We
therefore recommend using with cable of φ 3 to φ 7.6 mm.
Because wrap around tape has a strong adhesive, it may be hard to peel the film off the
backing. Refer to the following diagram for the peeling method.
Wrap around tape is thicker than typical label tape, so the half-cut may be shallower.
In this case, refer to "What To Do If the Cutter Is Getting Blunt" on page 130 to adjust
cutting depth. If it still does not cut, replace with new cutter. (
page 133)
If the half-cut is too shallow, the film may not peel from the backing properly.