Ink Low; No Ink Cartridge - Brother MFC-J220 User Manual

Error Message

Ink low

Low Temperature
Media Error
Media is Full.
No Caller ID
No File

No Ink Cartridge

No Paper Fed
No Response/Busy
Not Registered
Cause
One or more of the ink cartridges
are near the end of their life. If a
sending machine has a color fax
to send, your machine's
"handshake" will ask that the fax
be sent as black & white. If the
sending machine has the ability to
convert it, the color fax will be
printed at your machine as a black
& white fax.
The print head is too cold.
The memory card is either
corrupted, improperly formatted,
or there is a problem with the
memory card.
The memory card you are using
already contains 999 files.
There is no incoming call history.
You did not receive calls or you
have not subscribed to the Caller
ID service from your telephone
company.
The memory card in the media
drive does not contain a .JPG file.
An ink cartridge is not installed
properly.
The machine is out of paper or
paper is not properly loaded in the
paper tray.
The paper is jammed in the
machine.
The Jam Clear Cover is not
closed properly.
The number you dialed does not
answer or is busy.
You tried to access a Speed Dial
number that is not programmed.
Troubleshooting
Action
Order a new ink cartridge. You can
continue printing until the LCD shows
Cannot Print. (See Ordering
accessories and supplies on page ii and
Replacing the ink cartridges on page 51.)
Allow the machine to warm up.
Put the card firmly into the slot again to
make sure it is in the correct position. If the
error remains, check the media drive (slot)
of the machine by putting in another
memory card that you know is working.
Your machine can only save to your
memory card if it contains less than 999
files. Try deleting unused files to free some
space and try again.
If you want to use the Caller ID feature call
your telephone company. (See Caller ID in
chapter 5 in the Advanced User's Guide.)
Put the correct memory card into the slot
again.
Take out the new ink cartridge and re-
install it slowly until it clicks. (See
Replacing the ink cartridges on page 51.)
Do one of the following:
 Refill the paper in the paper tray, and
then press Black Start or Color Start.
 Remove the paper and load it again
and then press Black Start or
Color Start. (See Loading paper and
other print media on page 9.)
Remove the jammed paper by following
the steps in Printer jam or paper jam
on page 61.
Check the Jam Clear Cover is closed
evenly at both ends. (See Printer jam or
paper jam on page 61.)
Verify the number and try again.
Set up the Speed Dial number. (See
Storing Speed Dial numbers on page 40.)
B
57