Binatone iDECT C10i Single User Manual page 44

"When I key in a number, it appears on the display, but I cannot make
an outside call"
 Try a different position for the base unit – somewhere higher if possible,
or further from other electrical equipment.
"The phone does not ring"
 Check that the base unit's mains power adapter is plugged in and power
is switched on.
 The base unit needs mains power for normal operation of the phone –
not just for charging the batteries.
 Make sure you are using the telephone line cable that was supplied with
your phone.
 Make sure that the ringer volume settings are not set to off. Increase the
ringer volume settings.
"My call was cut off when I went out of range. Now I can't use my
handset."
 Move the handset closer to the base unit before you try again to make a
call.
"There is interference and noise on the line"
 Move the handset closer to the base unit, or to a different position.
 Try moving the base unit so that it's not near other electrical equipment,
such as a television or a computer.
 You'll get the best sound if you place the base unit as high as possible.
For example, in a two-floor building, the first-floor landing is an ideal
place.
"I hear 'beeps' from my handset while I'm on a call"
 You may be going out of range of the base unit.
 Move closer or your call may be cut off.
 Check the Battery Level symbol on the display.
 If it's low, recharge the batteries.
"The Caller Display feature isn't working"
 You need to subscribe to the Caller Display feature from your network
service provider.
 You should find contact details on your phone bill.
 The caller may have withheld their number by dialling 141. Or they may
be calling from a network that does not transmit the caller's number
(e.g. if they are making international calls.)
42