Deregister A Handset; Change The System Pin Code; Block List Setting - Binatone iDECT C10i Single User Manual

7.4.4 Deregister a Handset

This operation should only be necessary if one of your handsets becomes
faulty or lost and needs to be replaced.
A de-registered handset will have REGISTER YOUR HANDSET on the
display.
1. Press <MENU/OK>.
2. Press <UP/DOWN> to select ADv SETTING and then press <MENU/OK>.
3. Press <UP/DOWN> to select DEREGISTER and then press <MENU/OK>.
4. Modify the displayed PIN, if necessary, using <DEL/INT> to delete digits
and the keypad to enter new ones, then press <MENU/OK> to confirm.
5. Press <UP/DOWN> to select the handset number you want to remove, and
then press <MENU/OK> to confirm, and a confirmation beep will sound.

7.4.5 Change the system PIN code

The System PIN is used for registration / de-registration of handsets, setting
some functions and for accessing the answering machine remotely. The
default System PIN code is 0000. The maximum length of the System PIN
is 8 digits.
NOTE: If you forget your PIN code, you can reset it to its default 0000 using
a handset Reset (see 7.8).
1. Press <MENU/OK> to enter the Main Menu list.
2. Press <UP/DOWN> to select ADv SETTING and then press <MENU/
OK> to select.
3. Press <UP/DOWN> to select PIN and then press <MENU/OK> to show
OLD CODE.
4. Enter the current System PIN (default 0000) and then press <MENU/
OK> to show NEW CODE.
5. Enter your new system PIN (minimum 4 digits, maximum 8 digits), and
then press <MENU/OK> to show CONFIRM CODE.
6. Enter your new system PIN again and press <MENU/OK> to confirm it.
A confirmation beep is played.
7.5

Block list setting

The Block List allows you to program up to 30 phone numbers that you want to
block, and for which the phone will not ring nor accept at the answering machine.
CALL BLOCKED is displayed on the handset and in the Call Log, when a
call is received from a programmed number.
NOTE: This function is only applicable if you subscribe to the Caller Display
service on your phone line. The call will be blocked if the incoming Caller
Display number matches one stored in the Block List.
27