Handset Speakerphone; Adjust The Volume; Mute/Unmute The Microphone; Paging - Binatone iDECT C10i Single User Manual

4.3

Handset Speakerphone

During a call, you can press <TALK> to alternate between hands-free
speakerphone and normal handset use.
4.4

Adjust the volume

There are 5 levels to choose from for each of the earpiece and speaker
volumes.
During a call, press <UP/DOWN> to select from vOLUME 1 to vOLUME
5. The current setting is shown, and when you end the call, the setting will
remain at the last selected level.
4.5

Mute/Unmute the microphone

When the microphone is muted, the handset displays MUTE ON, and your
caller cannot hear you.
During a call, press <MENU/OK>/MUTE> to turn on/off the microphone.
4.6

Paging

The paging feature enables you to locate a missing handset if the handset
is in range and contains charged batteries.
Press <PAGE/FIND> on the base station. All the registered handsets that
are in range will produce the paging tone and show PAGING on the display
for 60 seconds.
You can stop the paging by pressing any key on any handset or
<PAGE/FIND> on the base again.
4.7

Switching on/off

If the handset is turned off, press and hold the <OFF> button for more than
5 seconds to switch it on. The display will show SEARCHING for a short
time until the handset finds the base.
To turn the handset off, press and hold the <OFF> button for more than 5
seconds in idle mode, until the display goes blank.
** You can switch the handset off and save battery charge, if the handset is
not on the base or a charger pod and you do not want to use it for a while.
NOTE: When the handset is OFF, it cannot be used for making calls
including emergency calls. There will be no ringing during an incoming call.
To answer a call, you will need to switch it back on and it may take some
time for the handset to re-establish a radio link with the base unit.
13