Figure 2-9. Removing The Hinge Covers And Icon Window Cover - HP OMNIBOOK 2100 Service Manual

3. Open the display fully.
4. Slide off the two plastic hinge covers about 5 mm, then lift them off. Use your finger or a small
tool to push outward next to the hinge.
5. Pry out and pop up the right end of the icon window cover at the plug-in module slot, then pop off
the cover.
Icon Window Cover

Figure 2-9. Removing the Hinge Covers and Icon Window Cover

6. Pry off the two screw covers by the hinges (use a pointed knife or probe), then remove the two
screws.
For a 12-inch display, pry off the two display bumpers at the top of the display, then remove the
two additional screws.
HP OmniBook 2100/3000/3100
Hinge Cover (2)
Screw Cover (2)
Removal and Replacement 2-13