Figure 2-7. Removing The Hinge Covers And Icon Window Cover - HP OMNIBOOK 2100 Service Manual

5. Pry out and pop up the right end of the icon window cover at the plug-in module slot, then pop off
the cover.
Icon Window Cover

Figure 2-7. Removing the Hinge Covers and Icon Window Cover

6. Remove the icon PCA by doing the following:
Unplug the IR/icon cable near the right end of the icon PCA.
Remove the screw from the left end and lift up the PCA.
Unplug the cable from the motherboard.
7. For the LCD cable emerging from the left hinge, remove the screw from the grounding lug inside
the base assembly. For a 12-inch display, also remove the second screw holding the LCD cable.
Then unplug the cable from the base assembly.
8. For the inverter/MB cable emerging from the right hinge, unplug the cable from the motherboard.
9. Remove the four screws from the hinges, and lift off the display assembly.
2-10 Removal and Replacement
Hinge Cover (2)
HP OmniBook 2100/3000/3100