Chain Looper - Baby Lock Cover Stitch BLCS-2 Instruction And Reference Manual

Chain Looper

T
1. With the presser foot up and machine lock button in the locked position, (fig. A pg. 13).
H
2. Place the thread cone or spool on the "Chain Looper" spool pin. Slip the thread into the telescop­
R ic antenna thread guide above the thread cone.
3. Insert the thread through the hole of the thread guide above the chain looper tension dial. Bring
E
the thread under the chain looper tension dial, then up and over the left thread guide,making sure
the thread is in the tension disk. (fig.A).
A
4. Take the thread down to the chain looper threading port.
5. Pull 18 inches (40cm) of thread and insert 1 inch (10cm) of thread into the chain looper threading
D
port. Use tweezers if necessary, to insert the thread end. (fig. B).
I
6. Depress the looper threading lever. (fig. B). If the thread does not go through the chain looper eye
with one push, depress the threading lever again until it does.
N
7. Open side cover to the left for easy access to the chain looper thread in tray (fig. C).
8. Trim excess thread to 4 inches (2.5cm) from the eye of chain looper and leave it hang.
G
9. Close side cover.
10. Move the lock button release lever to the right.
14
A
C
B