Thread Cradle For Looper - Baby Lock Cover Stitch BLCS-2 Instruction And Reference Manual

Thread Cradle for Looper

S
P
E
C
I
A
L
T
Y
T
H
R
E
A
D
S
34
1. Open the front cover and raise the presser foot.
2. At the threading port, cut the chain looper thread. (fig.A)
Remove thread from under the presser foot and the upper
thread guides. Replace cone of thread with specialty thread.
3. Place the machine in "locked" position to thread the chain loop­
er.
4. Thread specialty thread into the upper thread guides, leaving an
A
18 inch (40cm) tail above the threading port. (fig.C)
5. Cut a 24 inch (55cm) strand of serger thread and fold in half to
form a thread cradle. Insert the loose ends of the thread cradle
into the port about 1 inch (2.5cm).
6. Holding the cradle loop with left hand, depress the threading
lever with your right hand (fig.D) until the thread ends come out
the looper eye. Open side door of machine to make sure
thread is in eye of chain looper.
7. Insert the specialty thread tail into the cradle loop (fig.E), pull
B
the serger thread ends until the specialty thread comes through
the looper eye (fig.F). Discard or set aside the thread cradle.
8. Cut chain looper thread 4inches (10cm) and place in tray. Close
side door of machine. (fig.G)
C
D
E F G