Baby Lock Crown Jevel BLCJ18 Instruction And Reference Manual page 26

SPI
SR Style
Precision
Cruise
Figure 23
Regulated
Regulated Regulated
More
Stitch Mode
Stitch Mode Stitch Mode
Regulated
Regulated Regulated
Manual Manual
Manual
Needle Stop Needle Stop Needle Stop
Up
Up
Down
Down
Down
Regulated
Stitch Mode
Regulated
Manual
Needle Stop
Up
Down
Figure 24
10 SPI 10 SPI
SPI SPI
SR Style SR Style
Precision
Precision
Cruise
Cruise
Up
More
More
7 SPI
SPI
SR Style
Precision
Cruise
3%
More
Cruise
When "Cruise" mode is selected, when you press
"Start" on the handles the machine will immedi-
ately begin stitching at the percent speed indi-
cated below the "Cruise" button. The "Cruise"
speed is the minimum speed the machine will
stitch, regardless of how slow you are pushing the
machine. This means that when you slow down
to a stop, the needle will continue stitching at the
set cruise speed until you begin moving the ma-
chine faster than what the cruise speed is set to or
you press the "Stop" button on the handles. The
"Cruise" speed can be adjusted using the "+" and
"-" buttons that appear below the "Cruise" button
when "Cruise" mode is selected. "Cruise" speed
10 SPI
can be adjusted between 3% and 50%. (Figure
24)
SPI
SR Style
The start indicator box, which is the box at the
top center of the screen, will change from red to
Precision
green as soon as you press the "Start" button on
the handles. If you are in "Precision" mode, the
Cruise
needle will not start moving until you start mov-
ing the machine, so this green indicator shows
that the "Start" command was accepted and the
machine is ready to begin stitching. In "Cruise"
mode, the red box will turn to green and the
More
needle will begin stitching immediately at the set
"Cruise" speed.
On/Off Indicator
If the machine does not sense that it has been
moved in any direction after the Start button
has been pressed while in Regulated Mode with
SR Style "Precision" selected the Start Indicator
box will turn red. This will occur when machine
has been idle for approximately two minutes. A
system message will appear on the screen to warn
user that the machine has stopped. After pressing
the "OK" button the warning box will be cleared
from the screen. To resume quilting press the
Start button. For information on other buttons on
this screen, please refer back to the Manual Mode
screen.
23