Slide Rail And Table Assembly - Axminster AW10BSB2 User Manual

Fig 66
36
Screw the adjusting caphead bolt back
through until it touches the lower face of
the mounting bracket (36).
Locate the slide rail assembly (50), orientate it so that the longest rail is at the top, and the
channels etc., of the extrusion are underneath. Offer it up to the front bracket (36) and introduce
the square clamp into the main channel in the extrusion. The two open channels should fit over
the guide lands on the bracket face. Slide the assembly forward and repeat the procedure with
the rear bracket. Slide the assembly forward until it is set approximately equi-distant about the
brackets; tighten the lift and shift lever handles (A) to 'pinch' the slide assembly (50) in place.
(See figs 68-69 and 70)
Fig 68
Square clamps
Unscrew the slide rail assembly lift and
shift handles (A) to give the clamps plenty
of movement.
Fig 70
Remove the safety stop and the 'rubber buffer ring' (B) at the end of the top rail, place carefully
aside. (See fig 71) Locate the clamping plates (C) and clip them to ends of the rail assembly (50)
(See figs 71)
A
50
21
Leave the brackets at approximately the
same height.

Slide Rail and Table Assembly

50
Offer up the front bracket (36) and
introduce the square camp into the main
channel of the slide rail (50).
Initial Assembly
Fig 67
Fig 69
Fig 71
B