Axminster AW10BSB2 User Manual page 25

Fig 86
Place a level across the main and the
sliding tables to check both are level
Fig 88
Use the height adjusting blocks to adjust
the height of the sliding table
The overall setting process is done in 3
phases. 1) Setting the table level against
the main table; front and rear. 2) Setting
the sliding table/main table gap, to
ensure a parallel feed. 3) Raising the
sliding table slightly proud of the main
table. The reason it is done in this
manner and this order, is that phases 1)
and 2) are interactive e.g. tilting the
sliding table to bring it level can change
the gap between the two tables, (See fig
90) whereas if the tables are set level a
uniform adjustment to the brackets,
should not alter the level, merely the gap.
(See figs 90 & 91) The final phase is only a
'jacking' exercise and should not affect
the previous settings.
Make sure all the fixing bolts are
generally finger tight.
Place a level in the horizontal position on
the sliding table and adjust until it's level
The mounting bracket (36) fixing bolts (A)
and (B)
Fig 90
25
Setting the Machine
Fig 87
Fig 89
A
B
Continues Over....