Initial Assembly; Saw Body Assembly - Axminster AW10BSB2 User Manual

Unpack all the boxes and check all the components against the "Part's Index". If any parts or components are
missing, please contact our customer services department using the procedures and telephone numbers listed in
our catalogue, and you will be dealt with quickly and efficiently.
Please note: that, on occasion, the packing list is not strictly adhered to, please check all the boxes, packets
etc, to make sure that all the parts have been accounted.

Saw Body Assembly

Having unpacked the boxes, put the parts and
components where they are readily to hand. Break
down the main box by knocking the sides away (be
careful of exposed nails etc.), but leave the machine
sitting on its pallet. Identify the short rear panel with
the dust extraction cutout (2), locate the dust
extraction moulding (4) and fit to the panel using the
nuts and bolts provided.
(See fig 1) (The orientation of the moulding should
leave the 30mm outlet pointing upwards i.e. pointing
up the long length of the panel). Put the panel aside,
and locate the lower leg columns (3) and 4 No. M8 x 20
(5B) bolts, nuts and double washers. Fix the lower legs
to the upper legs using a washered bolt through the
legs and secure with washer and nut, only turn the nuts
Fig 1
Fig 3
PLEASE RECYCLE ANY UNWANTED
PACKAGING RESPONSIBLY
up finger tight at this time. (See fig 2) Locate the
extention table (), table support brackets (7), steel
clamping plates (8) and 4 No. M8 x 20mm caphead
bolts and washers (9A).
PLEASE NOTE: the manufacturer has fitted adjusting
bolts to the brackets, these are the faces that back
against the legs.
Offer the clamping plates (8) up to the inside face of
the legs (3), fasten the brackets using
washered bolts (9A) through the bracket and the leg
into the clamping plate. Tighten the bolts finger tight
only at this time.
M8 x 20mm
Bolt washer
4
2
8
09

Initial Assembly

Fig 2
7
Fig 4