Table of Contents
Advertisement
1. When you select SIG... from the Admin Procedure Screen, the telephone prompts you to
use the Right and Left navigation arrows to select a setting and displays the following text:
Setting: text string
where the text string is the wording associated with the current system value of SIG,
defined as:
"Default" when SIG = 0
●
"H.323" when SIG = 1
●
"SIP" when SIG = 2
●
Note:
The SIG value "Default" can represent either SIP or H.323 depending on the
Note:
upgrade file used for the telephone.
2. To change the setting, press the Change softkey until you see the setting you want or use
the Right or Left navigation arrow to cycle through the settings.
Depending on the current value, the next sequential text string is selected and displayed as
the setting. For example, if the current value is SIP (2), pressing the Right arrow changes
the value to 0 (default). If the current value is H.323 (1), pressing Right arrow changes the
value to 2 (SIP).
3. Press Save to store the new setting and redisplay the Admin Procedures screen.
The remainder of this procedure depends on the status of the boot and application files.
For information, see
Choice Selector
Appendix A: Restart
Scenarios.
Signaling Protocol Identifier
Issue 2 December 2007
41
Advertisement
Table of Contents
