Avaya 3616 Installation And Configuration Manual page 21

documentation on configuring your access points and other required security services on your wired
network. To configure Cisco FSR in your WT, you must enter a Radius Server username and
password into each phone.
Username: Enter a username that matches an entry on your Radius server. Usernames are
alphanumeric strings, and can be entered using the same technique as described above for
ESSID entry.
Password: Enter the password that corresponds to this Username.
OAI On/Off
The Open Application Interface (OAI) enables third-party computer applications to display
alphanumeric messages on the WT display and take input from the WT keypad. Refer to the Open
Application Interface (OAI) Specification (Version 1.2) documentation for information about
administering the OAI Gateway and the services it can provide.
If you have an OAI Gateway installed in your system, OAI may be optionally enabled in each WT.
You may select whether the WT should attempt to connect to the OEM OAI Gateway by choosing
either the Enable or Disable options in this menu.
If OAI is enabled, and an OAI IP Address is available to the telephone (either via DHCP or Static IP
configuration), the telephone will communicate with the OAI Server at power on, and periodically
while it is powered on. If you don't have an OEM OAI Gateway installed at your site, you should
disable the OAI feature to preserve network bandwidth and battery life.
555-301-107, Issue 3
May 2004
3616/26 Wireless IP Telephone
Installation and Configuration Guide
21