Wpower On Memory; Xsecond Vehicle Security System Operation; For Standard Remote Transmitter; For 2-Way Lcd Display Transmitter - Autopage RS-727LCD Operation Manual

W. POWER ON MEMORY:
This security system is equipped with circuitry that will allow the unit to remember its
alarm state if the power is lost and then reconnected.
X. SECOND VEHICLE SECURITY OPERATION:
Your 5-button remote transmitter can be utilized to control a second vehicle security
system, To program the remote control transmitter to a second vehicle, follow the
instructions for Transmitter programming.
Programming the Transmitter to 2
Enter:
1. Turn the ignition key ON 3 times. (Finishing in the ON position)
2. Press valet switch 2 times, holding in on the 2
chirp. (Release the valet switch)
3. Press the shift button of the Car 2 transmitter.
* The standard transmitter (II) is shift button.
** LCD transmitter must be put in 2
4. Press the lock button on the transmitter; you will hear 1 siren chirp.
Turn OFF the ignition switch; you will hear 3 long siren chirps to confirm programming
and exit transmitter programming
*

For Standard Remote Transmitter:

1. Prior to pushing any button on the transmitter. Press the Select II button first on
the transmitter.
2. Once II button is pressed the LED on the transmitter will illuminate for 3.5 seconds
to indicate the second transmitter pin code has built-in.
3. While the LED is illuminated, press any button on the remote control transmitter to
control a second vehicle security system.
**

For 2-way LCD Display Transmitter:

2nd Car Operation:
1. Press first, within 3 seconds press and hold
buttons at the same time for 2 seconds. Two beeping sound
and the " " icon will be displayed on the LCD screen to
indicate the second transceiver pin code is programmed.
2. While the " " icon is displayed on the LCD screen, you
can remote control and communicate with a second vehicle
security system. It has two short "bi" sounds while pressing
the button of the LCD screen transceiver.
Back to 1st Car Operation:
1. Press first, within 3 seconds press and hold
buttons at the same time for 2 seconds. One long beeping
sound and the " " timer icon will be displayed on the
LCD screen indicating the system is back to the first
transceiver pin code.
2. While the " " timer icon is displayed on the LCD
screen, you can remote control and communicate with the
first vehicle security system. It has one short "bi" sound while
pressing the button of the LCD screen transceiver.
nd
Car
nd
push, you will hear a long siren
nd nd
car mode to program for 2 car. (See below)
and
and
18