Autopage RS-727LCD Operation Manual page 4

TRANSMITTERS
The RS727 comes with two transmitters. The XT72LCD is a 2-way transmitter and
receiver, also referred to as a transceiver. The XT-65 is a mini-size 1-way transmitter.
Both operate on the AM band with a code-rolling feature that will prevent any illegal use
of a code-grabber attempting to record and steal the codes of your transmitter.
CHANGING THE BATTERY IN YOUR TRANSMITTERS
XT72LCD: This transmitter uses a standard 1.5-volt AAA battery. Information on
changing the battery can be found on page 5 of this manual.
XT-65:
This transmitter uses one (1) 3-volt lithium ion battery (#CR2032) that is
placed with the (+) side facing upward. To replace the battery, you will need to use a
small flat blade screwdriver and a small Philips screwdriver. Remove the small Philips
head screw. Then locate the small notch on the lower right side of the transmitter case
next to the key ring. Using the flat blade screwdriver, carefully pry the top case from
the bottom case. It should snap apart after breaking the seal. Before removing the
battery note the direction of the positive (+) terminal. Place the new battery in exactly
the same manner, being careful not to bend or damage the contact terminal. Snap the
cases back together and then test the transmitter to insure it arms and disarms the
alarm. Reinstall the Philips screw to finalize the battery replacement.
XT-65 Extended Range Sliding Cover remote
CR2032 3-Volt Battery
4