ATEN ALTUSEN PN0108 User Manual page 37

5. The PN0108's serial port settings and the computer's COM port settings
must be the same. Change the settings in your dialog box (if necessary), so
that they match the PN0108's COM Port settings, then click OK.
Note: The PN0108's default settings are 38400 bps; 8 Data bits; No Parity;
1 Stop bit.
6. When the HyperTerminal screen appears, open the File menu and select:
Properties → Settings. The following dialog box displays:
7. Change the settings (if necessary), so that they match the settings shown in
the diagram, then click ASCII Setup... The ASCII Setup dialog box
comes up:
Chapter 3. Logging In
27