ATEN ALTUSEN PN0108 User Manual page 16

PN0108 User Manual
(Continued from previous page.)
No. Item
3 Power
Control
Buttons
4 Reset
Switch
5 Station ID
LED
6 Power
Switch
6
Each button (A to H), controls the power status of its
corresponding AC output port as follows:
Pressing the button for less than 3 seconds toggles the port
between Remote Access enabled and Remote Access disabled
(Local Mode). If Remote Access is disabled, the switch does not
allow the port to be managed from a remote connection. (The
Remote Access LED is off when Remote Access Mode has
been disabled for its corresponding port.)
Under Local Mode, pressing and holding the button in for more
than 3 seconds switches the power to its corresponding port On
or Off.
Pressing and holding this switch in for more that three seconds
resets the PN9108 to its factory default settings. This switch is
recessed and must be pushed with a thin object, such as the end
of a paper clip, or a ballpoint pen.
The PN0108's Station ID displays here. If this is a Single Station
installation (See Single Stage Installation, page 11, or the First
Station on a Daisy Chained installation (see Daisy Chaining,
page 13), the PN0108 has a Station ID of 01.
This standard rocker switch powers the PN0108 On and Off.
Description