System Default Gateway Configuration; Route Configuration - Planet ADE-3110 User Manual

Gateway associated with the selected Network Interface, then that Gateway's IP
address appears in the Gateway field of the route entry.
If the selected Network Interface is dynamic but the connection is not established,
then the route entry does not appear in the Routing Table. When the interface comes
up later, the route entry is then added.

6.4.1 System Default Gateway Configuration

The system-wide Default Gateway provides three options: Auto (default), User-selected
Network Interface, and None.
l
None: It allows you to choose to have no Default Gateway in the CPE.
l
Auto (default): It allows you to enable the Router to automatically decide the Default
Gateway.
l
User-selected Network Interface: It allows you to select a Network Interface from a
list (PVCs, PPP Sessions and LAN). This option allows you to associate the sys-
tem-wide Default Gateway to a Network Interface, static or dynamic, and provides a
way to fix the Default Gateway to a dynamic Network Interface before the interface is
established.
l
Specify IP: It allows you to specify the IP address of the default gateway.

6.4.2 Route Configuration

Destination: It allows you to enter the remote network or host IP address for the static
routing.
Netmask: It allows you to enter the Subnet Mask for the static routing.
Gateway: It allows you to enter the IP address of the gateway device that allows the
router to contact the remote network or the host for Specified IP or select an Interface for
the Gateway.
Manually Configured Routes: It displays the static route entries entered by the user.
The options for this field are IP PVC0 ... IP PVC7, IP Ethernet
0, IP BridgeMux0, and any PPP session that was created by
the user.
43